Diffstat (limited to 'ssh.1')
1 files changed, 10 insertions, 10 deletions
@@ -34,7 +34,7 @@
.\" (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
.\" THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
-.\" $OpenBSD: ssh.1,v 1.116 2001/06/23 02:34:31 markus Exp $
+.\" $OpenBSD: ssh.1,v 1.117 2001/06/23 17:48:19 itojun Exp $
.Dd September 25, 1999
.Dt SSH 1
@@ -269,7 +269,7 @@ of
.Ss Escape Characters
When a pseudo terminal has been requested, ssh supports a number of functions
-through the use of an escape character.
+through the use of an escape character.
A single tilde character can be sent as
@@ -278,7 +278,7 @@ The escape character must always follow a newline to be interpreted as
The escape character can be changed in configuration files using the
-configuration directive or on the command line by the
+configuration directive or on the command line by the
@@ -510,8 +510,8 @@ Quiet mode.
Causes all warning and diagnostic messages to be suppressed.
Only fatal errors are displayed.
.It Fl s
-May be used to request invocation of a subsystem on the remote system. Subsystems are a feature of the SSH2 protocol which facilitate the use
-of SSH as a secure transport for other applications (eg. sftp). The
+May be used to request invocation of a subsystem on the remote system. Subsystems are a feature of the SSH2 protocol which facilitate the use
+of SSH as a secure transport for other applications (eg. sftp). The
subsystem is specified as the remote command.
.It Fl t
Force pseudo-tty allocation.
@@ -698,7 +698,7 @@ The default is
Specifies the cipher to use for encrypting the session
in protocol version 1.
@@ -883,7 +883,7 @@ The possible values are:
QUIET, FATAL, ERROR, INFO, VERBOSE and DEBUG.
The default is INFO.
.It Cm MACs
-Specifies the MAC (message authentication code) algorithms
+Specifies the MAC (message authentication code) algorithms
in order of preference.
The MAC algorithm is used in protocol version 2
for data integrity protection.
@@ -906,8 +906,8 @@ The default is
Specifies the port number to connect on the remote host.
Default is 22.
.It Cm PreferredAuthentications
-Specifies the order in which the client should try protocol 2
-authentication methods. This allows a client to prefer one method (e.g.
+Specifies the order in which the client should try protocol 2
+authentication methods. This allows a client to prefer one method (e.g.
.Cm keyboard-interactive )
over another method (e.g.
.Cm password )
@@ -979,7 +979,7 @@ Disabling rhosts authentication may reduce
authentication time on slow connections when rhosts authentication is
Most servers do not permit RhostsAuthentication because it
-is not secure (see
+is not secure (see
.Cm RhostsRSAAuthentication ) .
The argument to this keyword must be